23 January, 2025 · Blog
Installing a sink and taps in your kitchen can seem like a daunting task, but with the right tools and a little patience, you can accomplish it yourself. This post will guide you through the necessary steps so that you can enjoy a functional and well-equipped kitchen.

Preparation Before Installation
Before you begin, make sure you have the necessary materials and tools. Among them you must have both the parts to be installed and the tools to install the kitchen taps. From there you need to check the manufacturer’s instructions for both the sink and the faucets.
Installation of the sink
- Measure and prepare the space: If the countertop does not have a hole for the sink, you will need to mark the location with a pencil and cut it using a jigsaw. Make sure the hole is the correct size.
- Apply silicone sealant: Apply an even layer of sealant around the edge of the counter hole. This will help prevent water leaks.

- Place the sink: Position the sink in the hole and press it firmly so that the sealant makes contact. If the sink has bras, tighten them from the bottom to secure it in place.
- Connect the drain: Install the drain system following the manufacturer’s instructions. Make sure all joints are tight to prevent leaks.
Faucet installation
- Prepare the faucets: If the faucets are disassembled, follow the instructions to assemble them. Be sure to use teflon tape on the threads to prevent leaks.
- Place the faucets in the sink: Insert the pipes of the faucets through the corresponding hole in the sink. Adjust the fastening screws from below to secure it.
- Connect the water hoses: Connect the hot and cold water hoses to the water sockets on the wall. Use an adjustable wrench to tighten the connections without overdoing it, as you could damage them.
- Check for levelness: Use a level to make sure the faucets are straight. Adjust if necessary before fully tightening.

- Test faucets: Open stopcocks and test operation. Check that there are no leaks either at the connections or at the base of the faucets.
Final Tips
- Cleaning: Remove any excess sealant with a damp cloth before it dries.
- Check: Check all connections and gaskets after a couple of days of use to make sure everything is in perfect condition.
- Maintenance: Clean the sink and faucets regularly to maintain their appearance and functionality.
By following these steps to install the sink and taps you will be able to enjoy a well-equipped kitchen ready to use.